Projects & Foamboard Adhesive (LN-604)

This high-strength, low-odor, latex wall adhesive for indoor use features excellent long-term holding power and water resistance when set, yet it cleans up with water when wet. The flexible bond it provides bridges gaps up to 3/8". It's also considered a "green glue" because it's VOC-compliant.

  
 
wall adhesive

Key Features

Recommended For:

use as wall adhesive for foamboard, drywall, molding, paneling, plywood/hardboard, masonry/concrete, foam-back tub surrounds, corkboard, ceramic tile repair, furring strips and 1/8" thick medium-density fiberboard (MDF) paneling.

NOT Recommended For:

outdoor use, application of mirrors, marble, ceiling tile or wood flooring, underwater use, application of most tub surrounds (with the exception of foam-back tub surrounds), or bonding foam-back tub surrounds directly to ceramic tile.

Available Sizes

  • 10.3 fl. oz. cartridge

Coverage

  • Using a 1/4" (.64 cm) bead: 10.3 fl. oz. cartridge covers 32 lineal ft.

Max VOC

35 GPL

 
Get Adobe Reader to view certain LIQUID NAILS Adhesive product info

You need Adobe Reader to view PDF files.
You can download it here for free if you don't have it.

 

Surface Preparation

Make sure that all surfaces are clean, dry and structurally sound before this wall adhesive is applied. Do not apply wall adhesive to moist concrete or masonry. Note: One surface must be porous.

Product Application

Cut and pre-fit materials prior to installation. Insert tube of wall adhesive into caulk gun. Cut nozzle to desired bead size marked on nozzle. Puncture inner seal with nail or wire. Wall adhesive should be gunned at a room temperature of 60°F or higher. Adhere all materials before wall adhesive skins over.

Bonding Material To Furring Strips Or Studs

Apply a zig-zag 1/4" bead of wall adhesive to each strip or stud to be covered by material. Position materials so edges meet at stud center. Press firmly into place. Finishing nails are required.

Bonding Foamboard, Foam-back Tub Surrounds, Panels, Corkboard, etc. To Flat Surfaces

Apply 1/4" beads of wall adhesive over entire substrate in vertical zig-zag pattern. Beads of wall adhesive should be a maximum of 12" apart and within 1-1/2" of all edges. Bracing may be necessary until wall adhesive has set.

Drying Time

Working time up to 30 minutes. Dries in 24 hours. Fully cured in 28 days.

Cleanup

If the wall adhesive is wet, use water. If the wall adhesive has dried, use mineral spirits.